Just My Pictures!: Colours Of The Beach

Tuesday, 16 March 2010

Colours Of The Beach

Colours Of The Beach

It's not one of my favourite shots but I have put it up here anyway. It was taken on my 105mm prime lens with a high ISO rating to increase grain / noise to add more effect. I boosted the levels in PS and did a little cropping.

Pentax DSLR, 1/20sec f16, hand held exposure just about managed it without the tripod. ISO 800.

0 comments:

Post a Comment

Comments, A Note on Quality & A Question.

Please feel free to leave any comments, if you don't want it made public just email me instead. I try to encourage comments, ideas, criticism as this really is one of the best ways for me to grow artistically as a photographer.

Just so people are aware, I have saved all of these images for 'web optimisation', i.e they are greatly reduced in quality, some noticeble but most not. If you wish to have a copy of a photograph in better quality, or a sepcific size, please contact me at the email address/s on this page. Copyright applies to this site and its content, please see the copyright information below.

Finally, I keep getting asked 'what is the best camera to take pictures with?' and many questions along those lines. In truth it doesn't matter if you use a pin hole camera, a box brownie or £10 000 worth of kit. It is never the camera that makes a 'good' picture, it is almost always the person behind the camera. Pick up a camera and get out there shooting, apply a little technique and thought and you will be creating great shots in no time.

Thanks,

Chris

What you see, should be what you get!

How do you get your printer to match what is shown on your monitor / screen? I have been asked this question twice this week and a few times over the last month or so, so I'll try my best to answer it. I splashed out recently and bought a screen calibrator (less than £100). This means my photos will appear on any of my computer screens in the house with the same colours, cast and brightness etc. It also means any publishing house or printing company should see the same or very very similar, as all their screens will be calibrated too. I have my camera set to Adobe RGB colour setting (usually only found on DSLR's) as this is a common standard and I can set Photoshop to work at that setting. My printer was a bit more hit and miss however, without splashing out £350+ on a printer calibration system. I run test strips of a basic test print (many versions available online) showing a good selection of tones and colours, shades and contrasts etc. Very similar to what I used to do in my darkroom, allowing me to adjust the printer settings (colours, saturation, brightness etc) to match the paper in use. I then save this profile and use it everytime I use that particular ink / paper setup. I have a different setting for each type of paper I have, but it is the only way I can be confident that the print will match how I visualise the picture on my screen.

Just My Pictures!

Tuesday, 16 March 2010

Colours Of The Beach

0 comments:

Blog Archive

About Me

Comments, A Note on Quality & A Question.

What you see, should be what you get!

Copyright

Just My Pictures!

Tuesday, 16 March 2010

Colours Of The Beach

0 comments:

Blog Archive

About Me

Subscribe To

Comments, A Note on Quality & A Question.

What you see, should be what you get!

Copyright

Subscribe To